Pvc buckle board ye demolition?
Oh, I'll answer you! I am a decoration worker! Gossip less, first of all you look at your home PVC pin of the buckle which board
Head of the last piece of the width of the small, because the installation of the last piece of time, not necessarily the whole block! For example, the East is small, so that we have to start from the beginning to start! Find a blade inserted from the buckle slit, push to the corner of the corner, (if loose, then hand can also) you will see the last piece of a buckle only two sides of the corners attached! And then to the left or right to push, then congratulations you can get off the buckle! The last piece of demolition, how to split behind, is the individual will be! I do not have to install! How to install how to install!
Oh, I'll answer you! I am a decoration worker! Gossip less, first of all you look at your home PVC top of the buckle which one of the last piece of the width of the small, because the installation of the last piece of time, not necessarily the whole block! For example, the East is small, so that we have to start from the beginning to start! Find a blade inserted from the buckle slit, push to the corner of the corner, (if loose, then hand can also) you will see the last piece of a buckle only two sides of the corners attached! And then to the left or right to push, then congratulations you can get off the buckle! The last piece of demolition, how to split behind, is the individual will be! I do not have to install! How to install how to install!
Long strip pvc buckle plate is so demolished:
First of all, look at the installation when the pvc board and repair corners have not hit the glass glue, if the fight, it cut it with an industrial knife. And then put the word screwdriver or utility knife inserted in the last piece and the penultimate gap, gently swing up and down, while the last piece of pvc board is loose, then the board to the left or right side of the corner Push, there will be one side down, and then grabbed the side with both hands, gently down a pressure, slightly with the point of force, a pull, came out.
And then dismantling the inside of the board, it is necessary a cross screwdriver, and because each piece of pvc board will be on the tapping of the screw, the first under the self-tapping screws, and then slowly demolition, do not break.
Finally, open the pipe hole, the first to remove the board according to the direction of the release, (must be according to the direction) Oh, and then need to smoke pipe hole place to mark, and then buy the smoke pipe vertically on the mark, With paint strokes along the smoke pipe draw a circle, and then open the hole hole. Do a good job after the original path installed, surrounded by a good glass glue, on the line.
