Recently moved home, the refrigerator moved to the new home, did not plug, defrost first, about 16 hours after the first plug. But then the compressor didn't stop. Refrigeration normal. The freezer refrigerator 10 degrees - 20 degrees. Switch on in 4-5. It's been over 72 hours without downtime. What's the reason?.
Two reasons, one is that you're adjusting too low, the season is below 3, enough, and the two is defrosting or moving, and the thermostat is damaged
Generally transferred between 3 and 4, when the refrigerator room temperature at about 4 degrees down; you tune to 4-5, the refrigerator room temperature should be about 0 degrees down. The temperature of your refrigerator is still 10 degrees, not yet to the stop temperature. The reason may be that there are too many things in the refrigerator, the ventilation is bad, and the temperature is not easy to drop.
You switch the switch to 2~3 and try it. The switch in the 4~5 is a pretty cool one. If the seal is not good, it is possible to stop cooling.There is also the possibility that you move when the refrigerator is in the refrigerator across it.Because the compressor is driven by three springs supporting a suspension in a sealed cans, not fixed, if the refrigerator flat may make the compressor in the tank sealing position change, influence of refrigerator compressor work, sometimes even can not work properly. Then it'll be repaired.
Do not decide whether it is a fault or not. You did not plug, defrost first, it should be right, 16 hours, so that when it is carrying a little tilted, it has returned to normal. The key is when you defrost, it is natural melting, or with tools, is the use of hard cream? If not, there should be no problem. Then, in the refrigerator defrosting, especially open the door, let nature melt under the condition of internal close to the ambient temperature, as in the new refrigerator, to achieve the goal you set the temperature will have a certain amount of time. If it is hard to defrost, it is necessary to consider whether there is a slight leakage of the evaporator. I suggest you first set the temperature down, hit 2-3, to see if you can stop, and what the results are welcome to ask.
