As the computer for the chassis, into the wiring back, because the power supply 8PIN is not long enough to use 6PIN (graphics card, and later learned) interface into the 8PIN interface, can not boot. Now the problem is that I have purchased the extension of the line (not to, can not test machine), but do not know before plug the motherboard, or power supply has no effect. Will not burn the motherboard or power supply? Problem added: has been plugged in a boot, but the system did not start, the problem is not burn the motherboard or power, not to know may be, then I might as well do not ask more
Hello there! 6PIN graphics card can be transferred to CPU8PIN, or double 4PIN to a CPU8PIN, the server board dual CPU with no problem, it is recommended to use the 16 cable plus thick wire, 6PIN graphics and large 4PIN power supply capacity are more than 150W, capable of CPU power supply
Slowly try any kind of possibility is basically not far from the right answer Hope to help you
If the usb port power supply, plus an external power supply usbhub can be resolved. The The No power supply. Even if you change the power supply is not necessarily able to solve the lack of power supply. Power supply is to the motherboard power supply, the motherboard give you the usb wireless network card power supply.
Landlord put forward a good question. According to the principle of electrical engineering, grounding zero line can be placed on the ground, but also as usual to form a loop, does not affect the power supply, some people do not even pull the zero line, make a zero line into the ground to act as a zero line, but also work as usual. However, this will give the safety of electricity to bring a huge hidden danger: First, if the zero line placed in the low altitude or the ground, easy to be linked, pull off or affect other pedestrians, vehicles, buildings, etc., is not allowed; Their own system to do zero line, grounding resistance can not meet the requirements, resistance increases, will result in waste of electricity, management is very troublesome, but also does not work; Third, the zero line management is not standardized, will inevitably lead to poor contact, broken Problem, this time, the zero line disconnect point of the non-ground side of the voltage may be the same with the line voltage, or even make the user voltage from the phase voltage rise to line voltage, is extremely unsafe. Based on the above main reasons, the zero line must be the same as the FireWire configuration, the same management, and not because the zero line is free to set or place.
