Rules of operation for paver
Eleven, for the hydraulic automatic widening paver widening, we must pay attention to and observe the nearby situation, so as not to hurt people and damage equipment.Twelve, when paving in the use of liquefied gas tank heating, flameout or fire, etc., must be closed tank valve. When the ambient temperature is higher than 200C or the sun is straight, the gas tank is heated by gas tank, and the gas tank must be covered.Thirteen, after the end of the paving, cleaning materials conveying, tamping device, downtime, the ironing board must be placed on the pad wood, the machine parking shall not impede traffic, and should be placed warning signs. Run the engine idle for 5 minutes, then switch off, then cut off the power and lock the instrument panel.Fourteen, equipment maintenance must follow the requirements in the instruction manual.Fifteen, equipment maintenance, must:(1) the hopper and ironing plate are firmly fixed.(two) engine flameout.(three) when maintaining the hydraulic system, the residual pressure of the hydraulic system must be released.
Five, paver work before and after about leveling personnel contact, to ensure that other personnel are not in the work, can work.Six, in the file shift to the driving gear, must be in the small throttle, the machine completely stopped, the work of parts to stop working.Seven, operators are strictly prohibited drunk operation, operating equipment must be neatly dressed, no slippers, no smoking, eating and other acts that hinder safety operations.Eight. After the paver is in operation, all the protective devices must be installed in the designated position.Nine, the operating room (Taiwan) must be kept clean, cleaning up the oil and dirt in a timely manner, not misplacing tools and other items.Ten. The driver must leave all the operating mechanisms on the "0" position before leaving the operating platform.
A paver operator must go through professional training, to understand the mechanical properties, structure, master maintenance knowledge, master the machine performance and operating essentials and security matters, and confirmed by the relevant departments of qualified, can operate alone.Two, before starting the engine must be checked: oil (oil, fuel, oil, lubricating oil) is sufficient, fan tightness on the belt, there is no oil leakage and loose parts of its phenomenon. Check all the accessories, accessories and tools needed for the day's work.Three, start the engine, idle running for at least two minutes after the inspection of the monitoring system indicates whether or not normal.Four, material delivery vehicles must be directed, accurate discharge materials into the machine hopper.
