I bought a new skateboard, more than 300, but when I skated, I felt the tilt was too sensitive. My classmate bought a more than 100 board. I didn't think the turn was so sensitive. What's the point of turning too sensitive? Should I screw up the screws in the slab bridge? I feel it's hard to stand when the light does not go up, but it's OK to glide, when the downhill speed is too high, the center of gravity is unstable. Experts come to make a suggestion
The elastic slide nail should be the general bridge, front axle rear axle than to loose some of the bridge after the tightening of some help to turn to the middle of the bridge there is a snake, screw you tightly and then go slippery feeling is not free, if not enough, that is the PU pad on the bridge is too soft. Because of the reason of the weight, some overweight people will feel the slip for a period of time will feel the screw loose bridge, end or send, that is the problem of PU pad, Pu mat set good buy imported 60 yuan, hardness and elasticity are quite good, and then according to the first and then adjustment screw on the OK Bridge
You can tighten the main bridge nails and loosen the front axle to make sure the bridge is tight after the turnThis turn is good or bad is it depends on your personal preferences and some people love some people love the hard soft bridge bridge if you read Wang Huifeng's tutorial you can see the king HSBC Bridge really soft ah which depends on personal hobby but when I started to learn skateboard after selecting hard bridge skilled contrast after a try to choose their own soft Bridge
In addition PU not screwed tight screw is easy to burst when you ah downhill to center of gravity as long as there is little sloshing will sway more to shake you out is very dangerous if you want to break the recommendations from short to long to get used to not start at Changpo
More than 300, that is, the whole board, since bought first used to practice it, and so on, this board does not work, if you continue to play, you have to consider replacing the board, it is better to change the assembly board, 500 of the import of the bridge configuration
