Step into the motor drive red light for the cause of the failure
I'm now turning the drive down to 6400 Means I send a pulse to stepper motor drives It divided it into 6400 pulses to the stepper motor or I send 6400 pulses to stepper motor drives It sends a to stepper motor?
Red light is the failure indicator lamp, when the overpressure, overflow failure, the failure light is always bright. After the failure, the red light went out. When a driver fails, it is only possible to rewire and re-enable it to clear the fault.
Rezai MA860H stepper motor drives, ac and dc all can use power supply, with super wide voltage range, shall not exceed 90 v voltage is highest, the lowest not less than 24 v, Suggestions for 28-80 - v voltage range; It can be used in the 57, 85, 86 series and 110 series. There are 16 types of microsteps, the maximum number of steps is 51200Pulse/rev. The current range is 2.4 to 7.2 A, with A current of 8 and A current of 0.6 A. Automatic half flow, overpressure, over-current protection. The resai MA860H step motor drive has two red and green lights. The green light is a power indicator, and the green light is always bright when the driver is on.
