It can only be installed back to back? What if the main force is only one-way? Are there series installation or face to face installation, and this kind of bearing must be equipped with clearance adjustment device?
One way tandem, but the gap and concentricity to find good, or you do out of the work, the accuracy is not enoughFirst floor answer is very comprehensive, you can use thrust bearings try.
If you only have one direction axial force and no radial force, then you use thrust bearings. This kind of bearing, if it is a pair of erection, must be installed in this way, otherwise additional load will be added. This kind of bearing must have a gap adjustment device, such as using thread adjustment, gasket adjustment, etc.. Because this kind of bearings mainly bear heavy load, and often accompanied by alternating load, so it is easy to produce gaps. If it can not be adjusted in time, it will not only affect the whole machine, but also the bearing itself will soon be damaged.
Not to, is a relatively small cone angle. If you only have one direction axial force and no radial force, then you use thrust bearings. This kind of bearing, if it is a pair of erection, must be installed in this way, otherwise additional load will be added. This kind of bearing must have a gap adjustment device, such as using thread adjustment, gasket adjustment, etc.. Because this kind of bearings mainly bear heavy load, and often accompanied by alternating load, so it is easy to produce gaps. If it can not be adjusted in time, it will not only affect the whole machine, but also the bearing itself will soon be damaged.
