Tell God, tell me, what's wrong with this thrust ball bearing? How to change?
Thrust ball bearing is not your painting like this, two layers of inner and outer ring diameter have strict size, not you draw on the lower ring and the shaft with the inner diameter, outer diameter and hole, it can not be used, you check the parameters in the brochure. The inner hole D of the upper ring is matched with the shaft, and the outer diameter has a maximum value; the inner diameter of the lower ring is 2 larger than the shaft diameter, and the outer diameter matches with the hole.
Is your tightness still wrong?
Two wafer size thrust ball bearings are not the same. A piece of the diameter is fixed on the shaft, another large diameter hole. Some have one on the fixed place, a piece of the outer diameter and the fixed seat, and another piece of the outer diameter of the match where the size piece diameter you draw. This is not used. Two discs not have relative motion.
