MITSUBISHI system, spindle cutting out library tool change, how to return to the spindle
The first to see what is your knife, hats off the first switch to manual mode and then to the machine behind the two-way solenoid valve on the button, the knife can go back; then the first manipulator replaced manually, then rotated to the base motor is mechanical hand back, and then manually unloading knife, it OK
Press the top wrench on the machine, turn the lever back, turn 3 back on the library, and return to the correct positionAfter the killer return down the library there are 3 buttons on the knife edge of a knife is a knife a knife looseKnife back in itThe spindle does not move, form, unlock, hold down, press the press button to move quicklyOr press F1 on the control panel and press F2 to return to zero
What is behind the bed ah switch off is the SIEMENS system open loop control to open and see the coupling on the spindle or sensor should be the first analysis of the mechanical cause
