The problem of dowel bars on concrete pavements?
The dowel bar is arranged according to the transverse contraction joint and expansion joint set, meaning that a transverse contraction joint and expansion joint place dowels, are not plate must be set. In general, each 200m set a expansion joint, or other road intersection, and bridge connecting point must be set up.
Light bar shall be adopted for dowel barWith transverse expansion joint as an example: in the face of layer thickness is 220mm, dowel diameter is 28mm (28), the minimum length of the dowel bar is 400mm, the maximum dowel bar spacing is 300mm.
The left and right half of the casting, the middle of the set is a longitudinal pull rod, tie rod settings and your panel thickness and plate width, length of the boardTo Portland cement concrete surface layer as an example: when the plate is 3M, the thickness of the surface layer is 200-250mm, the rod Phi 14 * 700mm * 900mm rebar length and spacing from the lateral transverse joint distance not less than 10mm (mean distance is a piece of plate length is 4 meters to the two plates the net is not small 100mm).
