The rice cooker press down, no response
You said that this friend is a short circuit condition should be short heating lines, so when heated to this situation, a bright short, you try a few times, line stand, bursts open is very lucky results, so you immediately obtained conclusion the short circuit of electric cooker, then do not blind detection and analysis!! If you want to repair their own words, put the pot open, connected with the heating part of the line to see if there was a place was burned, and then look at the front line, charred parts if there is a fault, such as dust is very thick, there are many reasons why foreign body touch contact etc.!! But look, you will ask this question, I suggest you do not have to do it yourself, because you know too little about electricity, free to move, it is too dangerous, or to take care of it, the problem is not great!! If the parts are not broken, the parts need not be changed and the wiring will be ready
(1) the indicator light is not bright; the reason is that the power line is broken, repaired or replaced; the contact of the stable controller is bad; the sand can be removed after the sand paper is clean; the indicator lamp itself is out of order; the new one: the temperature fuse is broken. Replace new:(2) heating plate malfunction: do not heat, change new; can heat, but the heating plate deformation, also want to change;(3) cook cooked: because there is a magnet damaged, take-off magnet temperature less than 103 degrees on the take-off, cooking time and temperature which are not up to the normal value, resulting in rawish. The magnetic steel is improperly debugged and readjusted. Heating switch contact is bad, use sandpaper sand clean.
This is the short circuit condition should be short heating lines, so when heated to this situation, a bright short, you try a few times, line stand, bursts open is very lucky results, so immediately the rice cooker to short-circuit in the conclusion, the detection and analysis of blindly without, if you want to repair their own words, put the pot open, connected with the heating part of the line to see if there was a place was burned, and then look at the front line, charred parts if there is a fault, such as dust is very thick, there are many reasons why foreign body touch contact and so on. But don't do it yourself, because to know too little, free to move too dangerous, or repaired, the problem is not great, not bad parts, the parts are not for the next line. Just fine！
