Toilet water pipe seam water seepage, with raw tape tight, can you?
The pipe in the drain should be PVC, right? The correct way is to remove the leaking pipe or replace it with PVC special glue. Then it will be connected directly. The raw material belt and the black tape can not stop the leakage.
Note: the purpose of fighting waterproof guards is to make the water pipes inside the floor forming waterproof layer, so that water is not in the floor water seepage, so as to avoid other floor water seepage. The second is from upstairs. First check the water pipe and the ground seam is intact, whether there are cracks, cracks in the gap. If the gap is damaged, drying condition, put the loose broken filling materials clean, and then use the kitchen and toilet water spray over the ceramic tile aperture, 20 minutes after drying for the treasure of the joint damage to fill the gap tile.
One is the burst of the water pipe, and the other two is the joint of the ground and the drainpipeThe first is temporary treatment:Water pipes from toiletFill with seams. First, the water pipe around the putty layer and mortar layer shovel, and when the shovel can not move, you can see the cement floor layer, with a shovel to crack the water pipe opening, this is the seam of the water pipe and floor. With steel waterproof guards 1:3 against water, after the spray, let the jet water column, and pressure (the greater the pressure), the waterproof guards poured into the gap, the cement floor also spray some. Then they have sealant construction, sealing sealant into the syringe inside, to glue inside the gap, the weekend cement floor also corresponding with a layer of sealant.
If the water leakage is not very severe, it is OK to apply the glass glue outside the pipe and the leaking place, but the premise is that when the glass glue is applied, the pipe must be dry and keep for more than 12 hours at least.
