15. On a printed circuit board, electronic components will be mounted A. from the substrate side of the board. B. from the side of the board that contains the conducting paths. C. from the foil side of the board. D. from the side of the board that‘s covered with copper sheeting. 16. Which of the following statements about the measurement of electrical quantities is correct? A. Resistance is measured in units called ohms. B. Voltage is measured in units called amperes. C. Electrical pressure is measured in units called watts. D. Current is measured in units called volts.
After the new brake install, did you pump the lever to get the pressure back up to normal, or did you just install the pads, then install the caliper back over the rotor?
BLEED THE BRAKES, DUMMIES!!!!!! Tomcotexas.
bleeding the brakes cant do any harm so do that first(brake fluid should be replaced now then anyway) (it absorbs moisture). this may not fix the problem are the pads seated properly? are they the same make? are they the same material?
