Know of any online videos that show how to intall a cold air intake system? Preferably a Honda. but ill take anything
Most of the cold air intake systems come with directions to help with the install. They are fairly easy to install.
Here is a tech article rather than a video, but maybe this will help also. Good Luck!
ok i don't know the video site but i know the steps1st you have to lift the car with a jack from the front passanger side. next remove the tire from this side. because you have to take off the plastic under fender. next once this if off take out the bottom of the original factory intake. its a pain in the but to take this out with the tire on and the rubber under fender on as well. ok now remove the top half of the intake box completely all bolts screws everythingput all the blots in screws in place u can find them later as your going to beed them.now take off the rubber hose going into the throttle body, and remove all vacume lines and sensors. next put on the rubber cup that goes to the throttle body. tighten it. the cold air intake kit sends a rubber protector that is bog enough to fit inside the hole where you removed the top of the intake box. the round circle should be covered by this rubber so you have to make the rubber fit in and completely around the circle because the rubber has a cut in it and basically holds on while your pushing it around the circle. next put the first pipe into the throttle body this pipe has a minor bend in it. irs shorter than the other. next make sure you put the next rubber coupling on to the pipe you just attacedsecure this tightly as wellsome kits have a bypass others don'tso now last peice the long one goes down into the hole. now put the cone filter on. connect all the vaccume lines back on to the new pipes and sensors. put the rubber under fender back on and the tire. final step is to reset the batteryif you don't reset the battery it might cause check engine light to go on. now turn it on for like 109 min. then it should be ready but if check engine light goes on just unplug the battery and reset it again. this should cure it.finally your done.
