Home > categories > Construction & Real Estate > Tile > Want to tile a kitchen floor?
Question:

Want to tile a kitchen floor?

Dont want to lay down the rock. Want to attach strait to the plywood due to dish washer stove and cabinets. What is the best way for long lasting tile strait to plywood?

Answer:

The function of the Durock is to provide a mechanically attached transition from wood to tile. Without it, ceramic or porcelain tile will crack from the movement of the wood subfloor. You can do it right or do it over. It's your call.
You should not apply tiles on plywood, you'll be doing a great mistake, use a cement mortar directly on a concrete base, they'll last almost a lifetime....
Short cuts usually create more situations that take longer to rectify than actually doing the job properly. You will need to remove the toe kick from under the cabinets and adjust the height, you must make sure the tiles go at least 3/4 under the toe kick. With regards to the dishwasher, they usually have adjustable legs, I would look into that before you begin this project, you really should tile under the dishwasher. If you ever plan on selling, the tiles installed the way you plan to install them will surely reduce the value.
The first thing is I need to know is this laminate glue or snap together (do you want to save this floor ?) if you donot care this is how to remove your laminate First off figure which way the laminate is started this will give you a good starting point. this should just fold up ward ____/ like that once you start you should be able to take up thold laminate in 1 hour. make sure to remove all your wall base first., that is what holds down the laminate. After that is up you will have to determine what type of underlayment is on the subfloor. The most common is durock if you are putting down ceramic . If it is vinyl tiles you then should use luan (1/4 thick use the same thickness for the durock). You have to measure you length and width of the floor striking chalk lines to determine where your starting point is ( you do this with either type of floor).If you need more instruction e mailme.
Going straight to the ply wood sub floor will only result in failure of the tile to bond. There will be to much deflection in the floor , the bond will break between the thin set and the sub floor. There is a thinner system you can use called Ditra. Thin mat that is applied to the sub floor and then tiled over. If your dishwashers adjustable legs can be adjusted more or if they re all the way adjusted to max you can tile up to them. You ll still be able to get the washer out. I have seen one yet that can t be taken out,its a struggle but it can be done. I suggest the 1/2 cement board,properly installed, since this meets all tile codes,(both ATC and TCA) to properly support tile. Any questions you can e mail me through my avatar and check my qualifications there. GL

Share to: