I have two water well good water but not a lot of water .is it possible to hook two pumps up to one holding tank . if so how do I hook them up
DONT WASTE YOUR TIME. HAVE A PROFESSIONAL DRILL YOU 1 GOOD WELL.INSTALL A CONSTANT PRESSURE SYSTEM THEN YOU WILL BE HAPPY.
It should be possible, it would be best if both pumps were identical. They should be hooked up in parallel to increase flow rate.
it is very easy to do just email me. I'll send direction . I would say you have a small under ground stream of water . as you use the water from the well, it will take time to fill the well pipe again
Not sure I quite understand the question completely, but here goes. If you have one well of sufficient pipe size, usually no less than 1 1/2 coming up out of the ground, and a standard 1/2 - 3/4 hp pump won't pump much water out of the well, then the point is probably partially plugged with lime and crud. If that's the case, you can try putting muratic acid down the pipe, let it set for a day and then hook the pump back up and pump water for a couple hours out of the well. Or you can try shooting a 22 rifle down the pipe, sometimes the concussion of the bullet hitting the water is enough to push enough of the junk off the screen to allow a decent flow for a while. Or you can do the proper thing and have the point pulled and replaced, (you can do it yourself with a decent bumper jack and a well dri ver). Good luck
