Welders wear protective equipment which, there are several kinds of goggles, were introduced.
Special protective clothing for clothes, gloves and shoes
Welders must wear insulated shoes, wear special insulated gloves
Welding, the welder and other people around should wear dust masks, reduce smoke inhalation
Welding workers and the surrounding workers should wear a good labor insurance supplies. Do not wear a welding mask, do not wear colored eyepiece directly observe the arc light; as much as possible to reduce the skin exposed, summer banned shorts and short coat engaged in welding operations; conditional on the exposed skin can be applied to UV protective cream.
Of course, in a variety of circumstances, the welder's protective equipment are inconsistent, to be treated differently
? The answer was adopted by users
4. Safety requirements for welder protective shoes
(1) welder protective shoes should be insulated, heat-resistant, non-flammable, wear-resistant and non-slip performance.
(2) welders wear protective rubber shoes soles, should withstand the voltage of 5000V test qualified, such as flammable and explosive occasions welding, the soles should not have spikes, so as not to produce friction Mars.
(3) in the water when the ground welding and cutting, the welder should wear through the withstand voltage 6000V, test qualified waterproof rubber shoes.
5. Other protective equipment for welding and cutting
(1) welding, cutting the workplace, due to arc radiation, slag splashing, affecting the surrounding line of sight, should be set arc guard or protective screen, screen should be made of non-combustible material made of its surface should be painted black or dark gray paint, Should not be less than 1.8m, the lower part should be left with 25cm air circulation.
(2) welders climbing or in the place where the possible fall of welding, cutting operations used in the seat belt, should meet the GB720 and GB721 "seat belts" requirements, the safety belt on the safety belt hook should be linked.
(3) welders with helmets should be consistent with GB2811 "helmet" requirements.
(4) welders use the tool bags, barrels should be no holes, welders commonly used hand hammer slag shovel, wire brush and other tools should be connected firmly.
(5) welder used mobile lighting fixture power cord, should be used YQ or YQW type rubber insulated cable, wire intact without damage, no leakage of lighting switch, the voltage should be based on the scene to determine or use 12V safe voltage, lamp The bulb should have metal mesh cover protection.
