What are some of the common failures of forklifts?
The source power of the forklift truck is diesel, and the diesel engine can't be started: can diesel be turned around? Is the starting system normal (the starter and the relay are intact? Does the battery have sufficient power?) Right? Is the oil road unimpeded (the oil supply system has no trouble? Is there no oil? Is there air? Is the oil pump intact? Is the nozzle intact?) Right? Is the inlet system in good condition (the air filter is in good condition? Is the valve closed in good condition? Right?
Forklifts cannot be started with the following conditions: 1, the battery without electricity Failure of starter The key switch is bad 4, the oil pump does not supply oil 5, there was no oil tank 6, no oil 7, the crankshaft lock The engine was completely scrapped
First, if the generator is normal, if the generator is normal then it is the problem of the battery. The most stupid way to measure the virtual voltage of a direct battery is to charge the battery with a charger, and if it can't be plugged directly, the battery will be dead. Change generators or batteries. When you turn on the key switch, you turn on the key switch and start clicking. Change the starter 3, if the key switch is bad, start with a little bit of reaction fluid. In the key switch 4, the oil pump is not supplied with oil and this needs to be removed and sprayed. In exchange for oil pump or repair. There is no oil in the tank. Come on! There is no oil measuring tape. Add oil! 7 and 8, twist the key switch, and the motivation is normal, but you can't afford a car, or get up and stall. Repair engine!
