What are the common breakdowns in the automotive dryer?
Air compressor dryer inlet condition is good, normal, but output "(1{) is extremely poor, then there are two causes, one is the desiccant moisture, oil, thus blocking off the impurities exceed the standard, the other is on the dryer outlet hole; a one-way valve 2 stuck, that dryer is very long time without maintenance, please put a" dry assembly removed, a complete system maintenance
After the compressed air of the air compressor enters the dryer, the compressed air is leaked out through the throttle chamber, indicating that the piston or 0 ring seal in the dryer's throttling valve is damaged, out of slot and pulled out. Should be promptly checked, cleaned or replaced
After 50 thousand km or one and a half years, observe if there is water in the storage tank. If there is water, replace the desiccant. (2) if there is a leak phenomenon, the automobile air pressure can not go up, and then repair by air leakage
When the compression pressure reaches the required standard value, the exhaust valve D of the dryer can not stop under normal working conditions, indicating that the piston is caused by a foreign body, a strain or a dead card. The small piston and the sealing 0 ring shall be removed or checked or replaced promptly
