What are the reasons for the high water temperature of the loader?
Five. Check the water pipe in the water tankWater pipe is easy to damage early, should pay attention to see when there are no cracks and leakage phenomenon, found damaged should be replaced or repaired in time. The water tank should be perennial use antifreeze, it not only has a cooling effect, corrosion, because many tank loaders are copper, then pay attention to antifreeze liquid to clean the dirt so as not to block the water tank, the normal replacement of antifreeze should be about two years.Six 、 maintain the transmissionBefore the advent of the summer should also filter loader gearbox return oil filter replacement and maintenance, and pay attention to regular replacement and maintenance of transmission oil cooling and lubricating effect, avoid long-term use of the oil dirty or bad effect of gearbox. Use a period of time should pay attention to observe the transmission oil enough, when not enough time to add filling.
Two. Clean the brake discThe soil on the brake disc should be carefully washed. If it is too dirty, it will damage the piston dust ring for a long time, resulting in the corrosion of the piston, and finally cause the brake to bite. In particular, some stones should be cleaned in time so as not to scratch the brake disc. In the high-speed running highway should pay attention to use his nose to smell, if smell a burnt smell is immediately pull over and see whether the brake deceleration smoke, smoke phenomenon that the brake temperature is too high should stop to rest, avoid the brake failure caused by high temperature.Three, ventilation reduces engine temperatureIn summer, the temperature is too high will make the loader engine oil viscosity decrease in the work process, resulting in the loss of engine power to reduce the lubricating effect, in the hard work when the temperature is too high can open the side door ventilation hood to reduce the temperature of the engine.Four 、 fan drive beltCheck the fan drive belt, after long-term use, the belt will be tired, deformed and loose, change the belt, you should choose the correct type and length, properly adjust the belt tightness after installation.
The loader loader high temperature is one of the common faults, especially in the hot summer, more attention should be paid to cool the loader, to ensure normal work, the loader water plugging, thermostat damage, water plugging, engine cylinder gasket is damaged, dirty oil may cause the temperature rise of loader. There are several ways to reduce the temperature of the loader:Flushing radiatorFlush the radiator well. Be careful not to spray the grease onto the radiator, because the oil stains are not easy to clean. This will hold the dust firmly. The thicker it is, the sooner it will seal the radiator, and the oil will be warm and the water temperature will rise. The normal work of the engine water temperature should be between 70-80, high work load to allow 95 but try to avoid high temperature for a long time, can stop using idle cooling, don't immediately turn off, so the engine overheating caused bypulling accident. Check the tightness of the engine belt after cooling down. Such as boiling phenomenon, conditions should be to find a shade parking cooling, let the engine idle cooling down the temperature, use a wet towel to open the tank cover, to prevent water vapor to hurt yourself, then add enough water to the water tank.
