What are the requirements for regular lathe tool installation
Clamp machine tool The machine tool is used for the use of the common blade, and the blade is held in a mechanical clamping method. Such knives have the following characteristics: (1) the blade does not pass through the high temperature welding, avoiding the defects of the blade hardness caused by welding, the production of cracks, etc., which increases the durability of the tool. Because the tool is durable, the time is longer, the time of change is shortened, and the production efficiency is improved. (3) the tool holder can be repeated use, save steel and improve the utilization rate of the blade, blade by manufacturers recycling system, improve the economic efficiency, reduce the tool cost. (4) the blade after resharpening, size will gradually become smaller, in order to restore the working position of the blade, often on the tool structure is equipped with blade adjustment, in order to increase the blade grinding
The tip height is the same as the center of the main shaft, and the Angle of installation is based on the machining process and the tool
Make sure the blade is flat and the blade is flat on the edge of the blade. The center is high above the center of the center and it is not easy to run the blade
The end of the car, the tip of the blade must be the same as the center of the main shaft, the outside circle is high or low 40 and 50 silk is ok, again is not to drag a knife.
The type and purpose of the tool The blade is the most widely used single blade cutter. It is also the basis for learning and analyzing various kinds of knives. The lathe is used for various kinds of lathe, processing outer circle, inner hole, end face, thread, car slot and so on. The structure of the tool can be divided into the overall car knife, the welding tool, the lathe tool, the turning tool and the shaping tool. The use of indexable turning tool is becoming more and more extensive, and the proportion of the blade is gradually increasing.
