What if the forklift oil is burned and the oil is burned
I often encountered this kind of problem Generally have can solve the hand pump pump oil pressure under the condition of no pressure generally Oil is the oil pipe leakage Find a flat place If can't solve suggest the oil all check it again Whether there is supervision way broken place And also when you exhaust Is there a burst of to take a breather One is when you finished exhaust The exhaust valve after fastening increase pressure in oil pump for several times repeatedly
Gas in the tubing, not oil.Have you had electricity for half a day? Electricity is not enough,
First open the hood, and pull out the distributor of the central high tension line, from the cylinder block there is 6 or 7 mm, switch on the ignition switch, turn the crankshaft, view the high tension line to produce edm. If there is no spark, there is a fault in the low voltage circuit with short circuit, broken circuit or ignition coil and central high voltage line. Interchangeably disconnecting, closing contact, observing the meter pointer reading. If the current meter instructs the discharge 3 ~ 5A and the intermittent oscillations, the low voltage circuit is good, the fault occurs in the high voltage circuit. If the current meter pointer does not oscillate, it indicates that the low voltage circuit is broken. If discharge of large current of electric current meter, indicates that there is an iron failure in low voltage circuit. If the spark is too strong, it creates a blue and white spark. The low voltage circuit and the ignition coil are good, the fault is in the distributor and the spark plug high voltage circuit. From the top to remove the high tension line head, spark plug rocking-turn crankshaft to the body tries to fire, such as no fire should check the distributor rotor, distributor cap, and whether high subsection line leakage, is when the spark ignition timing shall be checked and the performance of the spark plug.
