What is stone crystallization maintenance?
1, construction procedure: stone ground surface cleaning, stone gap marble glue repair, whole ground ground dry grinding 6-7 times, ground treatment, crystallization treatment (K2, K3, whole ground drops) maintenance treatment (K1 drops), ground maintenance.2, after a comprehensive clean-up of ground stone stone ground crystallization treatment, paving finish overall smooth, no color, each stone between the diagonal ground flush, overall cleaning, use a clean dry mop to clean up the ground without sand, impurities.3, stone gap marble glue repair: stone surface cleaned, repaired to each stone above small spots and stone with raphe marble glue, the original stone with the color of marble near the glue to repair the damaged surface. Then use the slot machine dedicated to the original stone stone installation of the raphe re neatly cut slot, make the width of gap becomes almost, and close to the stone color on the marble glue to fill
Marble crystal face: marble floor cleaning clean, with stone powder or crystalline agent with crystal crystal surface grinding machine grinding and drying, grinding machine in under the weight of stone and let the crystal powder produce physical and chemical reactions in the synthesis under high temperature, crystals to form a compact protective layer, hard, polishing machine with special place the white cotton pad and the wire "Z" type uniform polishing, polishing dust by pushing a dust clean, after crystallization can enhance the color and brightness, but also to non slip, waterproof, oil etc..
The crystallization processing: K2, K3 and the spraying of the ground drops, while using marble polishing, cleaning machine with red scouring pad, K2, K3 with the same amount of water drops onto the ground, using 175 RPM wiping machine weight 45KG start grinding, heat the surface of the material crystal surface effect formed in the stone surface after crystallization.
Ground drying after grinding to use water machine on the ground water treatment and drying treatment of the whole stone ground using hairdryer, if time permits, can also use the natural air dry, keep the stone surface dry.
The whole floor grinding: marble glue after drying and grinding grinding on the overall use of the ground machine, the whole horizontal grinding, grinding key caulking glue at the stone between (corner stone between) and close to the wall, decorative style, special shape at the edge of the stone floor to keep the overall smooth, polished finish again and again for marble glue caulking caulking finish to continue for second times and then polished stone retreading machine with steel mill stone tablets from coarse to fine, a total of seven times to complete the burnish surface overall smooth, with steel wool polishing, polishing to achieve the design requirements of the degree of brightness (70 degrees), no obvious gaps between the stones.
