Friends sent the old air conditioning, when the demolition did not receive snow species, snow leakage. We ask people to install air conditioners, and when they find the outdoor air conditioner, the compressor stops for a while, but the fan is turned. The master said to have air conditioning and snow, with a little increase in what is said, 120, the compressor stops, natural snow cannot be added, read and then open the outdoor machine lid said capacitor is good, the conclusion is a bad compressor, and then suggest we change a second-hand room outside the machine.My question is..,When the compressor is out of order, why does it stop? Will there be a possibility, where not installed, the line did not take good and so on?Is there anything else that might have gone wrong?If you change a second-hand outdoor machine, is it also to 1.5P, GREE brand or what? Are there any other requirements?
You're in the pictureThere may be no bad placeWhen snow is planted with the masterThere is no vacuumingThere is air in the refrigerating systemCause high pressureCompressor protection stopVacuum again. FluorideThat should be all right.
You're in the pictureThere may be no bad placeWhen snow is planted with the masterThere is no vacuumingThere is air in the refrigerating systemCause high pressureCompressor protection stopVacuum again. FluorideThat should be all right.
The compressor is protected by high voltage, high temperature and overload. After the temperature drops, the compressor is automatically turned back to start operation. After the operation, the temperature rises again, and the overload protection is carried out again.The possible cause of excessive high pressure and its elimination:1, poor heat sink condenser. Check the cooling fan is rotated, the condensing tube if there is dirt, clean the condenser.2, too much refrigerant. Increase the compressor load, resulting in excessive pressure, appropriate to reduce the cooling dose.3, the pipe system is blocked. Refer to the pressure gauge to determine, eliminate, and re process the system.4, fouling or fouling of evaporator or filter screen. The air flow becomes smaller, the system pressure and temperature are not constant, and the evaporator or filter screen is cleaned.5, compressor start capacitor burnout. Capacitors need to be replaced.6, the compressor starting coil burned, unable to start operation, resulting in excessive starting current, protection device jump off. Only replace the compressor one way.
