Home > categories > Construction & Real Estate > Drains > What is the cause of the installation or the cause of the floor drain?
Question:

What is the cause of the installation or the cause of the floor drain?

What is the cause of the installation or the cause of the floor drain?

Answer:

Generally do the slope of the drainage pipe to 1% or more, both 1 meter of water pipes, slope to 1 cm above, 3 meters of water pipe slope to 3 cm or more. Because the toilet drain is more concentrated, and the drainage when the shower is a large area, the water can flow around, if the slope is not enough, it is easy in some of the relatively small places where the water or slow drainage phenomenon. So the toilet floor slope must be appropriate, should not be too large should not be too small, if the slope is too large, people standing on the above will feel uncomfortable.
Apr 5, 2017
There is also a way to solve the slope of the ground, either in the bathroom cabinet or toilet place to do a little slope, which is in case of toilet water, allowing water through the two places to drain drainage. The slope of these two places can be slightly more relaxed, close to the level, as long as there is a little slope of water can flow to the past. But in the shower where the slope should be moderate to increase the point.
Apr 5, 2017
There is also an effective way to solve the drainage slope, that is, to increase the floor drain around the slope, the floor of the brick toilets diagonal, the ground drain on the middle of the brick, so that the installation of the slope is very obvious. However, before the installation, the owner should dock with the master good, tell the master toilet tiles size and specifications, so that the master to install the floor drain.
Apr 5, 2017
You are now using the deep water seal to drain, because the deep water seal to leak the inner core is longer, the bottom of the core is likely to block a part of the water pipe, so lead to slow water, it is recommended that you look at this situation is not what I said This is the case, if it is, it is recommended that you can consider the use of T-type floor drain, because the T-type leakage is relatively short can be applied to all the sewer, it is recommended that you look at the stars to the floor, in our decoration industry reputation is good, with the people More, full copper material is better, relatively strong corrosive, hope can help you
Apr 5, 2017

Share to: