What is the cause of the overheating of the servo motor
4: the inner hole of the bearing is eccentric, and the shaft is wiped. : 5: the motor ends or the bearing cover are not flat; 6: there is no calibration of the coupling between the motor and the load, or the belt is too tight; 7: the bearing clearance is too large or too small; The motor shaft bends.
1: too much or too little. 2: the oil is not good to contain impurities; 3: the bearing and the shaft neck or the cover shall be mismatched (too loose or too tight);
Excessive load; 10: lack of phase; 11: wind tunnel congestion; 12: running too long at low speed; 13: the power supply is too large.
