What is the difference between good and bad toilet?
7, pay attention to choose a different way of drainage: the toilet according to the way the water can be divided into washed off, siphon and siphon centrifugal vortex and so on. Washed down and siphon drop water injection is about 9 liters or so, the sewage capacity, but flushing noise. Swirl-type water consumption is large, 13-15 liters, but it has a good mute effect. Obviously, the drainage effect should be the most important functional indicators. Test drainage method is to install the water tank, filled with water, put a toilet paper in the toilet and drop a drop of ink, a discharge without leaving traces, indicating sewer patency, toilet quality is better.
8, box accessories the most important, can guarantee normal flushing, see the tank accessories! Therefore, the wash basin can buy cheap, the toilet must not buy cheap. There is also a small tip: the proposed men can sit on the toilet sample to try, because the men with a little longer to the toilet Oh, or will be very uncomfortable Oh!
5, the design of the pipeline is scientific and reasonable impact on the toilet flushing effect. Under normal circumstances, in the purchase of toilet before the first try to flush. Formal standards, in less than or equal to six liters of water in the case of three flush, the toilet on average to be able to at least five water table tennis out.
6, pay attention to the amount of good mouth and the distance between the wall: the amount of toilet seat for the toilet nozzle to the vertical distance to the wall, and then from the "seat." 30 cm for the middle of the water, 20-25 cm for the back of the water, the distance of 40 cm above the front of the water.
3, high temperature fired toilet water absorption is very low, so it is not easy to inhale sewage, resulting in odor. And some middle and low toilet water absorption is very high, when the suction into the sewage is very easy to issue an incredible smell, and difficult to clean. A long time, but also the phenomenon of cracking and leakage. In the selection, you can gently hit the toilet by hand, if the percussion sound hoarse, unclear and so loud, then the toilet is likely to have split, or the product is not cooked.
4, in the selection of the time, but also hand into the toilet's mouth, touch the inside is smooth. If the rough feel that there is no glaze inside, so the toilet is easy to leak. And the toilet seat gasket should be made of rubber or foam plastic, such a strong elastic seal, sealing performance.
1, gently touch the surface of the toilet, if there is no rugged feeling, and feel the glaze and the body feel are very delicate, which shows that the quality of the toilet is better. If it is in the low-grade toilet, the surface of the glazed and the body will be relatively rough, dark colors, light irradiation will be found under the hole.
2, high-grade toilet because of the high temperature when firing, to meet the requirements of the whole porcelain, so weigh in the hands will have a heavy feeling. While the low-grade toilet firing temperature is low, the time is short, so did not meet the requirements of all-ceramic.
