My Anhua toilet flush when the stool can not be washed down, why can water leakage of this problem?
There may be clogging in the toilet bowl
Anwar after all, is the brand, do not check so much. As long as you call the local dealer, they will send home repair. This is the benefit of buying the brand
Will that be the case? If not, it would have to look at the original water tank has not changed the water level? Is not it down? If it is low can adjust a little higher
Because the size of the flushing, can affect the momentum, if you want to impose better, one of the methods is to increase the original water level, flushing and more strength, there can be adjusted by adjusting the row of exhaust valve row adjustment switch to extend the drain valve Of the closing time
First, if it is not clogged tightly, then go to the supermarket to buy a special suction toilet with the rubber suction, check the toilet back and forth press it a few times, it is easier to pass through the full water.
Second, the toilet after years of use, the lower part of the toilet, in the bottom of the elbow has two rotatable hex nuts, unscrew it can be deposited sediment and debris, etc., can shed their own (out) , Until the flow finished, and then restore its status quo, just fine.
Three, sewer pipe for a long time, rusty open, (now some did not stay this mouth) and some home decoration has sealed it (the ceiling no point inspection), then go to the supermarket to buy a Dredge the sewer dedicated pipeline, with this line while pressing down, while holding the other side of the sewer dedicated pipeline, and a regular side of the non-stop rotation, and with the other side of the hand, forced to press, press not into the time to copy Some, and then press again, so slowly press down, will the entire sewer dedicated pipe are pressed into, and then pull it out, and sometimes pull out a lot of hair, once will pass, Sometimes need two or three times.
