What is the clearance of the transmission gear for wire cutting (fast walking wire)? Is it effective to use the compensating gap during automatic feed? When there is a servo motor in the positive and negative direction, will there be a gap value (the clearance of the motor)?
Because I do not know the specific structure of your wire cutting machine, so we can only do general answer you, but I can tell you now, the line cutting machine feed part are generally synchronous belt + ball screw, almost no gap between what.
So the specific data should be tested several times before it can be decided. A good servo motor, which rotates alternately in a positive and negative direction, has very little clearance and can be neglected.
The normal value of this gap is below 0.1. The compensation gap is valid when automatic feed is used, but the compensation data for each device is different,
