What is the reason that jaw crusher does not cut material?
Jaw crusher in the crushing of the ore will occur when the card material.
In order to increase the service life of the crushing plate of the jaw crusher, it is necessary to improve the equipment and material selection, assembly and use, thereby improving the production efficiency of the jaw crusher and reducing the production cost.
In view of this situation, you can try some of the following methods:A: can take pre screening, pre washing ore, ore blending control of water, but some ore is difficult to deal with;Two: can also be pre screened, and properly increase the ore discharge; increase discharge efficiency;Three: also can reduce the spindle speed, increase the discharge mouth;Four: you can also adjust the discharge port, but the angle is not peaceful;On the other hand, before using a crusher, it is necessary to find out what basic requirements the crusher uses for the material. On the jaw crusher, such as broken is due to sulfur; sulfur contained a lot of dirt, so the more the material mixture, and the temperature of the material is too large, will lead to large viscous material in the crushing process, thus causing a blockage of the stem broken before. Therefore, in this case, it is necessary to ensure the drying of the material before the broken material, and also to ensure the purity of the material, so that it does not contain too much mixture.
When the jaw crusher meets the material surface water greatly, it is very easy to appear card material, ore crushing after plugging in the cavity down material phenomenon; or because the jaw crusher in crushing material, which mixed with mineral mud, resulting in not down.
