Home > categories > Home & Garden > Blocks & Roll Bags > How to maintain the lathe tool holder
Question:

How to maintain the lathe tool holder

How to maintain the lathe tool holder

Answer:

If the positioning and clamping action is normal, the push rod 11 is in contact with the corresponding contact 12, and the signal is sent to indicate that the tool changing process has ended, and the cutting process can be carried out.In addition to the positioning of the hydraulic cylinder and the positioning pin, the motor can also be used to drive the clutch to locate, as well as other indexing and positioning mechanisms.
Open the check, the ordinary lathe turret with old and new, open to find the damage in, say, the old pine lock off directly to lift the knife can be removed, the demolition of a new week is generally anti remember screw wire, remove the cover, which can disassemble parts, slowly observe there is a problem, most are rust, dirt and ash layer thickness will not cause, no live, no obvious wear and tear after cleaning equipment on the lookout to adopt good.

Share to: