The cutting surface of the optical fiber cutter is like this, what's going on?
Carefully close the cutting knife to see whether the two sides of the rubber gasket is intact. If intact, carefully observe the top blade to contact fiber piece arc area not intact, then the level of direction was much higher than the top blade gasket, with a 1.5mm as a benchmark, try not to go down fine cutting. The time can shake head check guide rail wear, wear, cutting blade to promote instability, how to adjust is good, the general cutter is used in the IKO guide, should not be so easy to wear. Unless cottage.PS is now some cutting knife, fiber clamp is not good to put the bare fiber will be placed when there will be such an end face.This is the way I transferred, upstairs from the next should be better.
Adjustable knife before, to ensure that the four fiber laminated pad is clean, no deformation, shaft bearing is normal; then the first turn, all faces turn over, go a little bit higher tone. If you do not know the chaos, the first transfer can not be cut, and then slowly to a little bit up. The key is to check the fiber laminated pad and tool, or how to adjust is in vain. In addition, the quality of the blade is also related to some of the poor quality of the blade is lower than the hardness of silicon dioxide, it is difficult to cut, how to tune useless.
The blade is high, it is recommended to turn down a little.
I do not know if you are in the optical fiber welding machine is not the Japanese cutter, Sumitomo, whether or not, a knife can only be cut 6000 times, Sumitomo is considered good. Generally buy the welding machine with a knife. If you don't, you can only go back to one, because if you cut it off, you can only prove that it's not working. Is disposable. Only changing one, should not be expensive, you want to, you can't cut a few times, so that the fiber section is not smooth. In this way, the welding of the fiber as if it is not very high quality. Generally a good knife, cut out of the surface is smooth and smooth. In this way, the general quality of the fiber is relatively high. Can only change, repair, then bad repair!