After the work of the machine tool, the knife is not changed, the time is good and bad, the circuit is not a problem, mechanical rotation is normal. What are the specific reasons
Processing part of the program in the preparation of T code, the need to change the target knife number, the principle is to achieve this. The current knife number in the system inside, find the target knife number, according to the shortcut to the principle of selection, to determine the positive and negative. And calculate the number of knives that need to be turned over to the counter. In normal operation, the knife counting switch is used to subtract. The difference between the number of targets to subtraction, a reduction of 0, the completion of the signal, the library to stop running. The reason for this failure may be caused by the loose count switch and the error count. Control PLC counter in the middle, to see whether one correspondence can determine where the problem!
In the tool holder in place to detect the device, and sometimes can not detect the signal on the non-stop, the replacement of the new good.
Check your phone when the good or bad adjustment should be able to keep the turret is not in place after the rotation of the signal to detect the location of the sensor block or the location of the adjustment of your Holzer like
