What is the transformer absorption ratio (R60 / R15)
Generally, the absorption ratio should be greater than or equal to 1.3 as the absorption ratio is acceptable.
ransformer absorption ratio (R60 / R15) is essentially the same as that of the shaking generator. It is a megger to measure the insulation between the transformer coil and the ground. In the measurement start time, 15 seconds to observe the insulation resistance value, 60 seconds and then observe the insulation resistance value, the observed 60 seconds of insulation resistance value in addition to 30 seconds of insulation resistance value is the transformer Absorption ratio.
Absorption ratio = R60 〃 / R15 〃
For the same insulating material: the moisture or defective absorption curve will change, so you can determine the insulation curve based on the insulation is good or bad, usually in megger in 15 seconds and 60 seconds of the insulation resistance ratio (This is the absorption ratio, expressed by the K value), because the insulation of the degree of moisture increases, the leakage current increase than the increase in the starting value of the absorption current is much more, expressed in the insulation resistance is: megger in 15 seconds and 60 seconds of the insulation resistance is basically equal, so the K value is close to 1; when the insulating medium is dry, because the leakage current is small, the current absorption is relatively large, so the K value is greater than 1. Experience: When the K value is greater than 1.3, the insulating medium is dry, so that by measuring the absorption ratio of the insulating medium, it is possible to determine whether the insulating medium is damped and K is a ratio which eliminates the geometric dimensions of the insulating structure , And it is the same temperature measured under the value, without going through the temperature conversion, the comparison of measurement results is very convenient.
