What kind of saw blade is used on melamine board?
A melamine plate ordinary machine do not collapse edge is not easy to do, generally need to use precise sliding table saw (also called the panel saw sawing).Two, the panel saw to be completed through two steps. First use the bottom slot saw slot, and then use the main saw blade to cut off.
The choice of the main blade cutting saw. Are all the basic 3.2MM thickness, aperture is usually 30 aperture is 305MM (outer diameter part soil saw is 250MM), in order to view more smooth, generally used in the majority of 96 teeth, but the price is relatively high, if the number of teeth is less enough that do not have to use the 96 teeth, 72 teeth, you can choose or 60 teeth can be. The shape of the tooth is usually more than that of the ladder, so that the section is smooth and less prone to collapse. So the general as follows: 305MM diameter * tooth number 96T* thickness 3.2* aperture 30- ladder flat tooth
The selection of the bottom slot saw is based on the design of the saw. If we can adjust the height of the table saw with a single slot can be realized and the thickness of the main saw blade unified, general specification: diameter 120MM * 24T * teeth thickness (2.8-3.6) * aperture 20/22; if can not adjust, need to use double slot blade through the gasket the thickness of the main saw uniform, general specification: diameter 120MM * teeth (12+12) T* thickness (2.8-3.6) * aperture (note 20/22, 12+12 mean, every piece of the number of teeth of the double tablets were 12 teeth). Of course, using a single slot through the blade height adjustment sometimes is not easy to achieve complete reunification, so there are a lot of people directly choose double slot instead of the saw blade, adjusting the relative simple and easy, but double slot saw higher relative prices.
Melamine board, commonly known as double faced particleboard. Because with veneer, so cutting time is very easy to break down, or cut out.