What's the mode of the water heater?
4. before heating the water heater, make sure the water tank is filled with water. Otherwise, it will cause the heater to be empty burning, damage the heating pipe and cause the temperature controller to trip. Water injection method: the mixing valve will be pulled to the hot water, and then open the tap water inlet valve. When the nozzle continues to flow out, it shows that the water in the tank of the water heater has been filled, and then it can be heated by electric heating.
1, open the mixing valve bath, the nozzle should not directly to the human body, when the water temperature is adjusted to use, to avoid the water temperature is too high or too low, causing discomfort to the user. When bathing, make sure that the water is not poured on the water heater, so as to prevent the water inside the heater from being short circuited and cause danger.
2. after the end of your bath, you should first spray away from the human body, then turn off the mixing valve, turn off the water heater power, and at the same time, the water in the nozzle will dry. The nozzle is hung on the nozzle support.3. if the user does not use the water heater for a long time, the water in the inner liner of the water heater shall be emptied to prevent water from deterioration, odor and interior fouling. Methods: closed drainage tap water inlet valve first, then pull to the hot water heater mixing valve, then the valve handle to pull to the horizontal position, when the water in the water heater through the safety valve pressure relief outlet and the drain pipe to drain.
