What's the reason the LED lights are flashing 0-10v
The main reason for the flash is the frequency, which has nothing to do with anything else You can't tune the light directly in a normal transformer The best light for leds is PWM, which is actually tuned It's not realistic for leds to be completely unblinking, but the average frequency is at least 100 hz You use a transformer to adjust, the provision of standard frequency 50 hz or mains, 50 hz is there must be a stroboscopic, but some lamp tape may not be too obvious, some are obvious. So, if you want to take the LED lamp dimming, suggest to buy a special dimmer, the price may be higher, to hundreds of yuan, if you have a light load is not very big, buy a bigger manufacturer of wireless dimmer, remote control, estimates that more than 200. Suggest using special voltage regulator to adjust, is the most important factors influencing service life of the LED current, the LED lights must provide constant current source, no matter how to adjust all must ensure that the current constant.
When the input voltage drops, the circuit current also decreases, reducing to less than the thyristor to maintain the current, the thyristor is shut off.
Thyristor conduction, the current will slowly decrease, the moment before to maintain current silicon controlled rectifier, because the time is very short, if the circuit could work, also can restart.
Thyristor conduction, circuit due to not resistance, due to the capacitor, inductor, there is current oscillation, when current oscillation to below the SCR to maintain current SCR shut off, and then trigger again.
It's clear that you chose the wrong tone No transformer adjustment There's no problem with each of them. The problem is that you're wrong
