Why does our company measure two mass flow meters?
If parallel, that is now the pipe flow is too large, install a will exceed the scope, only parallel two units can be solved.
If the series, then your company is really rich, the purpose is to make a comparison, it is estimated that raw materials are more expensive, if not, that is two irrelevant, but the requirements are higher in the pipeline!
By asking questions, it should be that the two flowmeters are mounted on a single line. So there are two possibilities:1, the pipeline two directions need to be measured (at different times), and mass flow measurement is directional;2, the tested medium is the key raw material or the value is very high, and the fault can not be allowed to cause the measurement interruption. Therefore, 2 redundant setting schemes are adopted.
