My friend's house recently renovated, bought XX brand floor, only installed only a few months to find the floor stitching at the end of the trough to read the tea, the more and more serious cracks. So he was looking for business repairs, businesses only to their home for a few walls on the wall, the repair, not only did not fix the problem is even greater, almost every crack can be effortlessly stuffed under a few business cards. He was very wondering why the floor will produce from the seam? Is not installed when there is any problem, re-install to pay attention to what the problem? Please give pointers. More
The reasons are as follows: 1, from the wet spring and summer season into the relatively dry autumn and winter season, continuous abnormal dry weather is only a solid wood flooring within the water a lot of out of nothing. 2, the sun direct exposure. 3, a long time open air conditioning, doors and windows closed, no moist air supplement. 4, pavement before the gap between the larger space, encountered dry weather gap is more obvious. Solution: no formal drying caused by the treatment. So when installed in the wood floor can be covered with a layer of plastic film, on the one hand play a moisture and prevent the role of wood flooring from scratch, on the other hand has a certain sound insulation effect. In addition, two or three days in advance to the wooden floor to be placed in the indoor, so that the wood to adapt to the indoor temperature, but also to prevent the wood floor from Alice.
The ground floor or the environment is too large and the expansion of the floor, when the ambient humidity is reduced, the floor water loss shrinkage, resulting in shrinkage is too large; the weight of the room Symmetrical display. Preventive measures include: selection of plastic pavement, the edge of the spring with the spring to withstand, to ensure that the floor does not move, so that the gap evenly distributed; the ground should be installed moisture film; indoor heavy furniture on the side. Tencent Asia Pacific home for you to answer.
Two points: ① floor itself, the original moisture content is relatively high. Flooring to the ground after the floor, it has changed the volatile water, causing the floor of the horizontal shrinkage from the seam, that is, the material itself with the problem of Tam Tam Tou read the tea over the water consumption is relatively large. ② When the manual installation, due to the installation of the staff on the floor moisture content do not understand. Then the installation process between the floor and the floor, he may be installed more loose, it will also increase the severity of the seam. Note: ① must first keep the ground dry ② two or three days ahead of the house inside the first contact with the air, the best water can be consistent with the floor. ③ because the floor in the installation process, be sure to install the partition, give it a certain amount of contraction space. In the installation of the time must have moisture-proof pad, moisture pad has two roles. One is the buffer between the floor and the keel is not hard to hit the Well Well, this way there is damage to the floor. The second words play a tidal effect, the floor as long as the attention of these few, I think the deformation coefficient is relatively small. Acceptance time is very important: the provisions of the seam can not be greater than 0.8 mm!
In short, the floor is not good quality, wood quit, encountered dry environment, will naturally shrink, the floor of the splicing will inevitably leave.
