Why does the ice machine work for 14 minutes before the ice is full?
There is a problem with the plate probe. Check the inlet solenoid valveThere may be a spool, you have these data is useless, it depends on the line and the computer board. If there is no switch off ice action, adjust the ice plate probe to the appropriate thickness
Hello, because you don't know your ice maker model and type, you can only give some general judgment. First of all, who would like to know the ice thickness control of your ice maker? Most mechanical ice thickness detectors and temperature control are now on the market. If it is mechanical, you see if your ice thickness is too thin, you can try to adjust thickness. If it is temperature control, you need to check it. Is there any problem with the temperature sensor?. If these are no problems, you need to check the water is normal, is not too little water, causing this phenomenon. If you exclude the water problem, you need to consider is not the control program and cooling problems, general ice machine control program set will be one of the most long time ice, ice machine at this time will be the longest ice ice shedding, if the cooling efficiency can not keep up, will you describe the situation the cooling efficiency is low, resulting in many, such as the condenser cooling is not good, the ambient temperature is too high, you are the best to look out the problem. I hope to help you.
Do not take off the ice, first of all see whether it has ice removal action; or frost electromagnetic valve problemsCheck method is available. Temperature probe has problems. Check to see if it has been blocked
Check the water level and the position of the water level probeIf there is no heat, that is the problem of defrosting solenoid valve, ice machine in the first 7 minutes before the start of the ice is usually not detected, ice machine water source temperature shall not be higher than 32 degrees C
