Ok, I am installing a rebuilt Engine on my 1989 Chevy Pick up C2500 w/ a manual tranny, but the tranny and the block dont seem to align well for the installation, I replaced the clutch and I cant get it to line up, any sugestions? The Transmission is still on the truck , since the Block came out aloneI am trying to install the block and have it on a crane while trying to aling the transmission and the blockPlease Help
well, I checked around for a G36 Hopup that would be an improvement, and all I found is the SRC, and I dont trust them myselfHowever, a prometheus hopup bucking (soft for yours bc its 400) would most likely raise accuracy and muzzle velocity a tadIf you have the money, a new motor might be a plus as well.
First thing you need to do is go to the auto parts store and get a clutch alignment ARBOR so you can align the clutch prssure plateIt doesn't cost much at on, maybe 5.oo bucks and it will save you timeNow that you have that done,you need to make sure the tranny is level,Before you raise the motor make sure that the back of the motor is a little lower then the first .By the way if you have a floor jack ,put it under the tranny and loosen the mounting bolt up just a little so you can have some wiggling room.If you have someone to help you ,let them ez the motor down while your under there watching everything come together.Just take your time and you should get it in .Good luck.
