I used the Z axis is on the workpiece surface, and to the factory processing center, why always on the workbench, I do not understand, please master detailed instructions on its tool steps and intentions, high marks ~ ~ ~!
It shows that the factory you are in is too generalIt's impossible for each piece to work on the workbenchShould be based on the situationIf you're a little more precise, you'll need to use the Z axis setterMore G43, because you learn to use only a knife when you go to school, the factory's workpiece must be multi process, so G43Set parameters for multiple knivesStudy hard
A simple table is facing good benchmark of different workpieces can not repeat tool there is a workpiece down to several knife so that you can have it to good use on the line when there is no other requirements
When programming, the base plane is the workbench
When programming, the base plane is the workbenchThe aim of the tool setting is to determine the position of the origin of the program in the coordinate system of the machine tool. The tool point can be located on the part, on the jig or on the machine tool. When the tool is set, the tool point should be coincident with the cutter location. The trial cutting method is the most widely used tool setting method in practice.
