Why should the tiles be soaked before the tiles?
Tile water method: to find a large basin, so that the brick can be completely immersed. However, we must pay attention to gently, to prevent the porcelain out of porcelain.
Tile soaked in water is to prevent the absorption of water cement mortar moisture, so as not to cause hollowing, shedding, and even cracks, especially for the wall paving, wall paving before the need for water sprinkler work, is the truth The Tiles more or less there will be some pores, before the shop soaked in water, is to allow its pores full of water, and porcelain tiles because of the larger density, porosity is much smaller, also makes the water absorption is very low.
Due to the different water absorption of different tiles, there is no specific standard. But the end result is to tile the water "drink full", no longer take the bubble so far. High water absorption, the bubble will be a long time. Rainy season because of its humid air, time should be correspondingly shortened; heat dry weather, the time will have a corresponding increase.
Tiles of water need to split the water absorption in terms of water absorption <0.5% in the paving when there is no need to soak, and kitchen and bathroom with glazed tiles and tiles, water absorption is generally greater than 10% It is necessary to carry out soaking (if the porcelain wall for the brick, water absorption of less than 0.5%, of course, no need to soak). As consumers asked in the morning, you can have the following answer: Eno polished brick water absorption rate of 0.5% or less, can be ignored for the non-absorbent, the bubble will be the surface of the anti-fouling wax washed, the construction of poor protection It will pollute or draw the brick.
