Home > categories > Hydraulic & Pneumatic > Water Pump > Yang Chengtai big, the pump power is too small, the water pump will be bad?
Question:

Yang Chengtai big, the pump power is too small, the water pump will be bad?

Yang Chengtai big, the pump power is too small, the water pump will be bad?

Answer:

Generally not only affect water output, followed by what water pump. Generally small water pump buried too much, sealed less than required, easy to water, causing the motor to burn down.
Related to water pump structure, when the pump head is higher than the rated pump head, the current will increase, the water discharged from the pump impeller, back to the inlet of water from between the impeller and the casing exceeds the rated value, if it is a high lift pump, clearance between the impeller and the casing is small, the water pump current increases with increasing lift, current too much faster than the rated value, the motor will burn; if it is a low lift pump design, when the clearance between the impeller and the casing of the strict requirements, and even some of the water pump, the outlet is blocked, the pump will not burn. The drinking water pump used on the table, generally used non-toxic latex diaphragm pump, the head is too much, will damage the diaphragm part, the motor because the circuit has protection, the motor is not easy to damage. Generally do not risk good, according to the actual situation, select the appropriate lift, suction pump.Yang Chengtai large! If the pump power is too small! The pump will break! But not necessarily bad, mainly determined by the pump structure.
No, only when the operation of the low lift point is super power (burning motor), high lift point operation, low efficiency, small amount of water, or even no water. For example, a nominal 10 meters pump, flow rate of 10 square / hour. The actual lift 15 meters, the water pump is small or no water. The actual head is 5 meters, traffic may 20 square / hour, this time may exceed current, the motor may burn.

Share to: