Zebra GK888t print one, then flashing red light can not print, how to get it is not good, thank you!
It is definitely a low level fault. The height is slightly larger than the actual height of the paper.
You can restore the factory settings, see other methods to answer, if not, the printing preferences in the advanced settings for thermal thermal thermal and thermal transfer, if the place is grey cannot be changed, GK888t driver installation manual, (the default installation is EPL suffix) installed thermal change.This type of printer will often encounter paper clattering, master, I will teach you how to solve, and put out the ribbon down, on the left side of the roller with the screwdriver, unscrew the two screws both inside and outside, the inner side of the adjusting screw, and can easily turn to keep no gap, then it is well the line
Check whether there is paper (does not seem to appear this low-level fault, Hei hei); check whether there is jam phenomenon, the printer roller often because there are scraps of paper accumulated, so there will be such a cardboard phenomenon. Open the lid and observe that if the paper is stuck, pull it out slowly.
