To fully clean up the surface of the screen, and wash hands your hand with clean water( to remove the electrostatic), and tear the the (marked 1 face), one end of the stick screen mobile phone along the first edge alignment film, then slowly down film. Finally, tear to B membrane surface (a standard surface)!
To use the gummed paper, or use your fingernails gently buckled film a angle, tilt angle will slowly, then pinch the tilt angle, you can tear down the hand can be used, but not good Jie, length width tape stuck to a corner, the tape will be the film tearing up and if you film inside accidentally wipe clean, dust to form bubbles, can also use sticky tape out of Oh, can not be used in military, is easy to leave them a shadow of their former selves.
1. The quality of the protective film is good and also bad. And if your film is with a better quality, the electrostatic adsorption film good exposing more directly with the edge of the nail tip from the screen protection paste opened a corner, it is easily torn, and electrostatic principle does not have glue, the screen will not have residue left behind. 2. If the stick membrane is with a poor quality, it will be very difficult to be removed. And the most terrible is that the screen will be left with defective gum. After it is tearing off, you should use the screen cleaner or medicine alcohol to clean the area with defective gum. After the defective gum is melt, you can rub it with a little time and strength.
