I want to make such a simple bookshelf. How do I fix it on the wall?
First, cut the shape of the board, vertical and horizontal lines. 3 vertical planks must be of the same size. The shelves are free to place. Or large or small, large, you can put two thick classical and album. They just need to make some changes in length and width. The trick is to cut beautiful arcs. The horizontal panel is basically straight, but only bent at 40 cm from the end.
Materials: three pieces of wood (2700*120*18), 2 to 3 pieces of cardboard of the same size (preferably three plywood), 3 long screws with screws, paint and varnish.
The most complicated step in the whole process is to accurately see the horizontal and vertical fitting notches. Each transverse cut out three notches from the center of a mouth, two 20 cm two mouth. The notch on the vertical plate by their own needs to cut, because it directly determines the size of the space lattice. Adjust the position of the incision according to the size of your book. You can refer to my data: the floor of the photo album, the distance between the two notches, followed by 33 cm, 30 cm, 26 cm. Measure accurately, mark well, then cut. The shelf is not balanced if the measurements are not accurate enough. All incisions should be 18 millimeters wide so that the boards can be plugged in. As for the incision, that is, the depth of the notch, that's where the trick is. The riser is curved, so not all the notch are cut into the same depth. It is recommended that the incision be less 1/2 than the average width. For example, the width is 12 cm, the incision is 6 cm, the width is 6 cm, and the incision is only 3 cm.
