1325 woodworking engraving machine specific how to operate?
The handle is connected to the control line engraving machine, open the control power, and then open the main power supply (Prohibition charged USB handle on the engraving machine). When the handle screen prompts "whether to return to the origin", you must press the bottom left key to return to the machine origin, complete the initialization of the machine.
When the tool set processing, must be key in carving work before, the XY axis coordinates to zero, then the Z axis will be zero, when the screen showed the XYZ axis is 0, the system will automatic memory processing the origin of this operation, for the next processing call; then according to the screen pop up 3 to be processed data file (a total of 9 files, through the cycle, when the search page) to find the file processing, the corresponding number key according to the front of the first out of processing the file name, later out of the processing parameters (automatic processing speed, automatic air speed, speed ratio), which "rate" can increase or decrease, minimum 0.1, maximum is 1; the actual processing speed by automatic processing speed and speed ratio of multiplication and accumulation.
At this time, move the motor head around the handle; move the front and back movement of the Longmen; move the spindle motor up and down, and let the tool close to the surface of the machined material. The general practice is the first mobile XY axis, roughly to point location, and move the Z axis: first time through the key switch to low speed state, in the lower part of the left handle screen state display, through the key switch into a continuous way, close to the observed tool material surface, again by switching a stepping mode in the lower left corner of the screen as a hint, through the press to activate the spindle motor, make cutting tool in high gear, when the speed is stabilized, the tool point on the surface of the material.
