Home > categories > Lights & Lighting > High Pressure Sodium Lamps > 4 1000W high pressure sodium lamp and 8 150W metal halide lamp light source receives the same power source, the voltage is low, the lamp can not start. What shall I do?
Question:

4 1000W high pressure sodium lamp and 8 150W metal halide lamp light source receives the same power source, the voltage is low, the lamp can not start. What shall I do?

To do a large sculpture lighting, metal halide lamp and 4 1000W 8 150W for the light from a lamppost from power, but the voltage is too low, the 4 1000W sodium lamp metal halide with the remaining 8 150W cast light lamps are unable to start. Turn off the lamp after the halogen light can start. Ask an expert to point out, how can you light all lamps?

Answer:

The wire is not enough current, so change the thick wire Three phase power should be ok
This is caused by insufficient power supply. What are the reasons?Is the capacity of transformer introduced into street lamp line enough?The lamp wire diameter meets the current lamp with 4 1000W metal halide lamp and 8 of your 150W light requirements,Is the line diameter of your 4 1000W sodium lamps and 8 150W gold halogen light lamps introduced from the street light enough?
Test and connect 180 F/450V capacitor to improve the power factor, reduce the line current, reduce the voltage drop caused by the line loss, and maybe make the lights light up.

Share to: