im having some trouble with my windshield wiperswhen i turn them on and back off the keep going and somtimes the stop in the middle of my windshield and my wiper fluid motor does not operate all the time eitherbut it dosent do it all the time, kinda like the delay or relay switch is bad or going out
gm had problem with this ther is a curcuit board in wiper motor take screws that hold cover on replace curcuit board by pulling board out problem solved
These had a recall on them for this type of thing. What is wrong is in or on the wiper module. Remove the cover from the motor and pull the board out. If it's full of water of the rubbing bars are worn out, replace it and seal the cover to the case. Phone a dealer to see if it's still recalled as some of these had a time limit.
Make sure the fuses are seated properly in the fuse panels, and check all of the connections to both the fluid pump and the wiper motor. It sounds like you have either a bad connection, or perhaps a relay that is failing. Because the wiper fluid pump doesn't operate all of the time either, the possibility of a loose connection to the system, or a partially broken feed wire or failing relay is quite likely. You need to do some trouble-shooting on the electrical system. Pull the relays and clean the contacts on them. Pull the connectors apart and check for corrosion, and also check your GROUNDS for the electrical system. Wipers are set to run when you try to use the wiper fluid pump, and yours sticks on, so it is most likely that the relay operating that system is the root source of the problem.
